- #What is genesys logic usb2.0 card reader used for serial
- #What is genesys logic usb2.0 card reader used for drivers
- #What is genesys logic usb2.0 card reader used for full
- #What is genesys logic usb2.0 card reader used for pro
HKLM, Software\Microsoft\Cryptography\Calais\Readers, Vendors must also add a section to properly configure the smartcard services.
#What is genesys logic usb2.0 card reader used for drivers
Vendors that supply their own reader drivers should make each driver a member of the SmartCardReader setup class in the INF Version Section of the driver's INF file.
#What is genesys logic usb2.0 card reader used for serial
Support Serial Peripheral Interface (SPI) for firmware upgrade to SPI Flash Memory via USB interface.Support Read/Write quad data access (512Bytex4) for MS PRO-HG to enhance the transmission rate.
#What is genesys logic usb2.0 card reader used for pro
#What is genesys logic usb2.0 card reader used for full
Support Secure Digital TM v4.0 UHS-II: Full Duplex Mode and Half Duplex Mode.Support Secure Digital TM v3.01 UHS-I (Ultra High Speed): SDR12/ SDR25/ SDR50/ DDR50/ SDR104.Support Secure Digital TM v1.0/ v1.1/ v2.0/ SDHC/ SDXC (Capacity up to 2TB).Support CompactFlash TM v6.0 with PIO mode 6 / Ultra DMA mode 7 and LBA48 (capacity up to 144PB).High efficient DMA hardware engine improves transfer rate between USB and flash card interfaces.Embedded high speed 8051 micro-controller.USB2.0 transceiver macrocell (UTM), Serial Interface Engine (SIE), embedded Power-On Reset (POR).Support 5 Gbps SuperSpeed, 480 Mbps high-speed, and 12 Mbps full-speed transfer rates.Support 1 device address and up to 3 endpoints: Control (0) / Bulk Data Read In (1) / Bulk Data Write Out (2).
Support USB Mass Storage Class Bulk-Only Transport (BOT).Comply with USB Mass Storage Class Specification rev.Comply with Universal Serial Bus Specification rev.Comply with Universal Serial Bus 3.1 Specification (USB 3.1 GEN 1).It also integrates 5V to 1.2V DC-DC as alternative to improve the power efficiency. It integrates 5V to 3.3V and 3.3V to 1.2V regulators and power MOSFETs which can reduce system BOM cost. It supports Serial Peripheral Interface (SPI) for firmware upgrade to SPI Flash Memory via USB port. The G元225 integrates a high speed 8051 microprocessor and a high efficiency hardware engine for the best data transfer performance between USB and various memory card interfaces. It also supports high density memory cards (Capacity up to 2TB), such as SDXC, ultra high speed memory cards, SD3.0 UHS-I and the latest generation high speed memory cards SD4.0 UHS-II card. The G元225 is an USB 3.1 GEN 1 Multi-LUN card reader controller, it provides 4 LUNs (Logic Unit Number) which can support various types of memory cards, such as CompactFlash TM, Micro Drive, Secure Digital TM(SD), SDHC, miniSD, microSD (T-Flash), MultiMediaCard TM (MMC), RS-MMC, MMCmicro, MMCmobile, Memory Stick TM (MS), Memory Stick Duo TM (MS Duo), High Speed Memory Stick TM (HS MS), Memory Stick PRO TM (MS PRO), Memory Stick PRO TM Duo (MS PRO Duo), Memory Stick PRO-HG TM (MS PRO-HG) and MS PRO Micro.